| voltajlimiter |
| |
- Classification:Hardware/embedded - SCM(51,AVR,MSP430...)
- Development Tool:C-C++
- Sise:59.0 KB
- Upload time:2014/4/5 3:09:55
- Uploader:yashpal
- Download Statistics:
|
| Description |
This program along with electronic diagram makes Electrical household appliances limit between 180 VAC and 240VAC. Written in AVR Studio and used ATtiny84 microcontroller.  File list:
delay.h
DIAGRAM_AVR.BMP
tinyADC.c
tinyADC.h
voltajlimiter.c
voltajlimiter.cproj
voltajlimiter.h
|
| Related source code |
[MODELLING AND SIMULATION OFPHOTOVOLT...] - The work presented in this thesis describes the development of a computeraided design (CAD) package for photovoltaic (PV) arrays. The CAD package,
which is based on the MATLAB software, has been specifically developed to
investigate the performance of, and obtain the characteristics of a twodimensional PV array under partial shading conditions. Partial shading is an
important phenomenon in PV systems as it can lead to multiplicity of
maximum power points (MPP) and complex terminal characteristics, which
complicates the requirements placed on the maximum power point tracking
(MPPT) algorithm. It is therefore, important that the effects of partial shading,
and indeed temperature, on the characteristics of a PV array are studied. The
2 CAD package developed in this work was tested for characterising a PV panel
against the manufacturers’ data sheets. The effects of partial shading on the
characteristics of PV arrays were investigated for a variety of conditions with
particular reference to the complexities partial shading has on the maximum
power tracking strategies. The tests concluded that partial shading and
varying temperatures resulted in reduced outputs and power losses, thereby
affecting the performance of the PV array. The package, which is based on the
two-diode model of a PV module, provides a convenient tool for the PV
designer and/or a trainee.
[Voltampermeter-(thermostat)] - Voltampermeter with thermostat ATMEGA8 and LCD16x2
[Voltage-security-power] - Voltage security constrained active and reactive power pricing considering reactive market power
[259-Study-of-Photovoltaic-Water-Pump...] - water pumping system
[3leveland5levelstatcomforfaultvoltag...] - 3 and 5 level statcom for voltage improvement, disturbance is due to symmetrical fault of 0.01 ohms. The voltage was compensated completely
[a_novel_dc_capacitor_voltage_balance...] - capacitor voltage control for multilevel statcom
[AC-voltage-controller-upload] - AC Voltage Controller
[simple-voltameter] - simple voltmeter using pic16f877a with micro c
[voltage sag] - this fiels describe the voltage sag in the network by adding three fault in the line
[currentavoltage] - CS5463 measurement chip and MCU SCMAtmega16 development of three-phase voltage and current combined meter can display three-phase voltage or current, voltage and current available key switch. And with two alarm, and all 4
|
| Download Address |
 DownLoad
|
| Comments: Don't forget to comment after downloading! Comment... |
|
